DIY ElectronicsLive on KickstarterKickstarter

XPAD: Design, 3D Print & Program Your Own Control Pad

Build a modular control pad that's yours—from the 3D-printed enclosure to the firmware. Build it, program it, and learn how it works

Created by Welch · Launched Aug 24, 2026 · Closes Sep 28, 2026

Source: public Kickstarter page · all funding figures & images via KickstarterView on Kickstarter →

Raised

$6

Goal $1K

Backers

1

1 data points

Funded

1%

Of goal

Time Left

34 days left

BackerLens analysis

🟡 Below the DIY Electronics category average. This project has hit 1% of its goal, while the average live DIY Electronics project on Kickstarter sits at 3012% (100% below the category).

Early Momentum: 6 / 100 — low potential. Project is in its first 31 hours, so the score reflects funding-velocity-per-hour rather than 24h trend.

Compare against 18 other live DIY Electronics projects →

Back this project on Kickstarter →

BackerLens tracks the public Kickstarter listing. We are not affiliated with the creator.

More breakouts in DIY Electronics

01

KSVENTYRA R1 — Portable Wind Power System for Off-Grid Freedom

DIY Electronics·US

$170K

11328% funded

+8.2%

24h

54

LENS

02

KSiomixer - visual programming for STM32

DIY Electronics·NZ

$3K

60% of goal

+3.6%

24h

22

LENS

03

KSHovercore: 3D Printable Single Brushless RC Hovercraft STL

DIY Electronics·IT

$993

425% funded

+3.0%

24h

44

LENS

04

KSCABLETIME ScreenDock: Built-in Screen. More Than Just Ports

DIY Electronics·US

$92K

3079% funded

+1.7%

24h

50

LENS

See all DIY Electronics projects →

EARLY MOMENTUM

🆕 NEW

6/ 100

Low potential

Project is too new for 24h trend data. Score is based on funding velocity per hour, backer signups per hour, and staff-pick early signal.

Hours since launch31h

Funded so far1%

% per hour0.02%

Backers1

Staff pickNo

FORECAST

BETA

~$57

Predicted 6% of goal — at risk

○ Low confidence (early)

How is this calculated? ›

BackerLens uses an empirical Kickstarter funding curve: ~30% of final pledged comes in days 1-3, ~70% by 85% of duration, then a final-week push to 100%. We divide current pledged by where the curve says we should be at this point in the campaign.

Project is in its first day or two — forecast is highly speculative and will tighten as more data comes in.

This is an experimental model. Don’t bet sourcing decisions on a single number — the funding curve cross-section is just a heuristic.

Want alerts on projects like this?

Open BackerLens Free →